Mazda 3 manuals

Mazda 3 Service Manual: Rearview Mirror Installation

Mazda 3 Service Manual / Body / Mirrors / Rearview Mirror Installation

1. Install the rearview mirror onto the base.


2. Connect the negative battery cable. (vehicles with auto light/wiper system).

Power Outer Mirror Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Remove the front door trim.. 4. Disconnect the power outer mirror connector. 5. Remove the bolts. 6. Remove th ...

Rearview Mirror Removal
1. Insert a tape-wrapped flathead screwdriver to the position shown in the figure and press the center part of the spring in the direction of arrows (1), and then pull out the rearview mirror in t ...

Other materials:

Heated Oxygen Sensor (HO2 S) Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the HO2S connector. 4. Remove the HO2S u ...

Roof Carrier Bracket Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Sunroof seaming welt (vehicles with sunroof) b. Front scuff plate. c. Rear scuff plate. d. A-pillar trim. e. B-pillar lower trim. f. Upper anchor of the front seat belt installation bolt. g. B-pillar up ...

Rear Washer Hose Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Disconnect rear washer hose A from the washer motor. 4. Remove the rear washer hose A from clip A, B, C, D, E, F, G. 5. Disconnect joint pipes and remove rear washer hose A. 6. Partially peel back the sea ...

� 2016-2026 Copyright www.mazda3tech.com