Mazda 3 manuals

Mazda 3 Service Manual: Rollover Valve Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Emissions / Rollover Valve Inspection [Mzr 2.0, Mzr 2.5]

NOTE:

1. Perform the fuel tank inspection..

Quick Release Connector (Emission System) Removal/Installation [Mzr 2.0, Mzr 2.5]
Quick Release Connector Type CAUTION: Verify the type and location, and install/remove properly. Except for Mexico Mexico Type A Removal CAUTION: Be careful not to da ...

Rollover Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
NOTE: The rollover valve cannot be removed as it is built into the fuel tank. 1. Remove the fuel tank.. ...

Other materials:

Input/Turbine Speed Sensor Inspection [FS5 A EL]
CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. On-Vehicle Inspection 1. Perform the following procedures. a. Remove the battery cover.. b. ...

Vacuum Hose Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the charge air cooler cover.. 2. Remove the charge air cooler.. 3. Insert a thin flathead screwdriver at the point indicated by the arrow in the figure, push the ring down and disconnect the vacuum hose from the intake manifold. 4. Remove the vacuum hose from the vacuum hose c ...

Turning the Engine Off
WARNING Do not stop the engine while the vehicle is moving: Stopping the engine while the vehicle is moving for any reason other than in an emergency is dangerous. Stopping the engine while the vehicle is moving will result in reduced braking ability due to the loss of ...

� 2016-2026 Copyright www.mazda3tech.com