Mazda 3 manuals

Mazda 3 Service Manual: Purge Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Emissions / Purge Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Airflow Inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the purge solenoid valve..

4. Inspect airflow between the ports under the following conditions.



Measured condition

Continuity between A—B

When voltage is not applied between terminals A and B

No airflow

When voltage is applied between terminals A and B

Airflow detected


Positive Crankcase Ventilation (PCV) Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the intake manifold and the fuel distributor component as a single unit.. 4. Remove in the order indicated in ...

Purge Solenoid Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove in the order indicated in the table. 1 Purge solenoid valve connector ...

Other materials:

Side Air Bag Sensor Removal/Installation [Standard Deployment Control System]
WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the side air bag sensor.. 1. Switch the ignition to off. 2. Disconnec ...

Rain Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it. 3. Disconnect the rain sensor connector. 4. Slide rain sensor tab B in the direction of the arrow shown in the figure and detach tab B. ...

Oil Pressure Switch Removal/Installation [FS5 A EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. 1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the aerodynamic under cover NO.2.. 2. Remove in t ...

� 2016-2026 Copyright www.mazda3tech.com