Mazda 3 manuals

Mazda 3 Service Manual: Spark Plug Removal/Installation [Skyactiv G 2.0]

Mazda 3 Service Manual / Electrical / Ignition / Spark Plug Removal/Installation [Skyactiv G 2.0]

CAUTION:

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the plug hole plate..

4. Remove the plug hole plate bracket..

5. Remove the ignition coils..

6. Remove the spark plugs using a plug-wrench.

7. Install in the reverse order of removal.

Spark Plug Removal/Installation [Mzr 2.3 Disi Turbo]
CAUTION: If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing. 1. Remove the battery co ...

Ignition Switch Inspection [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the ignition switch.. 4. Verify that the continuity between the ignition switch terminals is as indicated in t ...

Other materials:

No.12 Torque Converter Clutch (TCC) Non Operation [FS5 A EL]
12 Torque converter clutch (TCC) non-operation DESCRIPTION TCC does not operate when vehicle reaches TCC operation range. POSSIBLE CAUSE Basically, the TCC does not operate when the fail- ...

Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION: If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. Removal of the passenger-side seat Loosening and retightening of passenger’s seat fixing bolts Or, the vehicle is involved in a collision ...

Fuse Replacement
Replacing the fuses on the vehicle's left side If the electrical system does not work, first inspect the fuses on the vehicle's left side. Make sure the ignition is switched off, and other switches are off. Open the fuse panel cover. Pull the fuse straight out with the fuse pul ...

� 2016-2026 Copyright www.mazda3tech.com