Mazda 3 manuals

Mazda 3 Service Manual: Starter Disassembly/Assembly [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Electrical / Starting, Charging / Starter Disassembly/Assembly [Mzr 2.0, Mzr 2.5]

1. Disassemble in the order indicated in the table.

2. Assemble in the reverse order of disassembly.



1

Magnetic switch

2

Adjustment washer

3

Rear housing

4

Brush and brush holder

5

Armature

6

Yoke

7

Planetary gear

8

Front cover

9

Lever

10

Drive pinion

11

Internal gear

12

Gear shaft


Starter Cut Relay Removal/Installation [MTX]
Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable.. 2. Remove the following parts: Front scuff plate (LH). Front side trim (LH). ...

Starter Inspection [Mzr 2.0, Mzr 2.5]
On-vehicle Inspection 1. Verify that the battery is fully charged. 2. The starter is normal if it rotates smoothly and without any noise when the engine is cranked. If the starter does no ...

Other materials:

Suspension SST
49 T034 1A0 Coil spring compressor set 49 0180 510B Preload measuring attachment 49 B034 001 Guide 49 B034 002 Guide 49 T028 3A0 Ball joint puller set ...

Check Valve (One Way) Inspection [Mzr 2.3 Disi Turbo]
1. Disconnect the vacuum hose connected between the check valve and the purge solenoid valve from the purge solenoid valve.. 2. Disconnect the vacuum hose connected between the check valve (one-way) and the intake manifold from the intake manifold.. 3. Blow through the check valve (one-way) ...

Antenna Amplifier Removal/Installation
With Audio Unit (Without Display) 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the fo ...

� 2016-2026 Copyright www.mazda3tech.com