Mazda 3 manuals

Mazda 3 Service Manual: Starter Cut Relay Removal/Installation [MTX]

Mazda 3 Service Manual / Electrical / Starting, Charging / Starter Cut Relay Removal/Installation [MTX]

Advanced Keyless Entry And Push Button Start System Only

1. Disconnect the negative battery cable..

2. Remove the following parts:

3. Set the hood release lever out of the way..

4. Remove the lower panel..

5. Disconnect the connector.


6. Remove the nut.


7. Remove the starter cut relay.

8. Install in the reverse order of removal.

Starter Cut Relay Inspection [MTX]
Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable. 2. Remove the following parts: a. Front scuff plate (LH). b. Front side trim (LH). c. Side w ...

Starter Disassembly/Assembly [Mzr 2.0, Mzr 2.5]
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. 1 Magnetic switch 2 Adjustment washer ...

Other materials:

Clutch Pedal Position (CPP) Switch Inspection [Mzr 2.0, Mzr 2.5]
Continuity Inspection 1. Verify that the CPP switch is installed properly.. 2. Remove the battery cover.. 3. Disconnect the negative battery cable.. 4. Disconnect the CPP switch connector.. 5. Verify that the continuity between CPP switch terminals A and B when the clutch pedal is depress ...

Cell Phones
WARNING Please comply with the legal regulations concerning the use of communication equipment in vehicles in your country: Use of any electrical devices such as cell phones, computers, portable radios, vehicle navigation or other devices by the driver while the vehicle is ...

Manual Transaxle Removal/Installation [G35 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

� 2016-2026 Copyright www.mazda3tech.com