Mazda 3 manuals

Mazda 3 Owners Manual: Tire Maintenance

Improper or inadequate vehicle maintenance can cause tires to wear abnormally. Here are some important maintenance points:

Tire Inflation Pressure

Inspect all tire pressure monthly (including the spare) when the tires are cold. Maintain recommended pressures for the best ride, top handling, and minimum tire wear. Use the pressures specified on the vehicle tire information placard or tire label for optimum service.

Glossary of Terms
Tire Placard: A label indicating the OE tire sizes, recommended inflation pressure, and the maximum weight the vehicle can carry. Tire Identification Number (TIN): A number on the sidewall of ea ...

Tire Rotation
To equalize tread wear, rotate the tires every 12,000 km (7,500 miles) at the latest or sooner if irregular wear develops. Mazda recommends to rotate every 8,000 km (5,000 miles) to help increas ...

Other materials:

Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]
1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Front scuff plate (Passenger-side). b. Front side trim (Passenger-side). c. Dashboard under cover. d. Glove compartment. e. Lower panel (Passenger-side). f. Shower duct ( ...

Oil Seal (Differential) Replacement [Fw6 A EL]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Remove the oil seal. a. Drain the ATF.. b. Disconnect the drive shaft (LH) from the transaxle.. c. Disconnect the drive shaft (RH) from the joint shaft.. d. Remove the joint shaft.. CAUTION: ...

Pressure Sensor Removal/Installation [Two Step Deployment Control System]
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Remove the bolts. 6. Remove the pressure sensor. 7. Disconnect the connector from the pressure sensor by pressing the ...

© 2016-2025 Copyright www.mazda3tech.com