Mazda 3 manuals

Mazda 3 Service Manual: Transaxle Oil Inspection [A26 M R]

Mazda 3 Service Manual / Engine / Lubrication / Transaxle Oil Inspection [A26 M R]

1. Park the vehicle on level ground.

2. Remove the aerodynamic under cover No.2..

3. Remove the oil level plug and gasket.


4. Verify that the oil is near the brim of the plug port.

Manual transaxle oil

Item

Specification

Grade

API service GL-4

Viscosity

SAE 75W-80


5. Install a new gasket and the oil level plug.

6. Install the aerodynamic under cover No.2..

Rear Oil Seal Replacement [Mzr 2.0, Mzr 2.5]
1. Remove the transaxle.. 2. Remove the flywheel (MTX) or the drive plate (ATX).. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 ...

Transaxle Oil Inspection [G35 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. I ...

Other materials:

DSC Off Switch Removal/Installation
1. Remove the switch panel in the direction of the arrow shown in the figure. 2. Disconnect the connector. 3. Remove the DSC OFF switch in the direction of the arrow (2) shown in the figure while pressing the tabs in the direction of the arrow (1). 4. Remove the DSC OFF switch. 5. ...

Air Mix Actuator Removal/Installation [Full Auto Air Conditioner]
Driver-side 1. Disconnect the negative battery cable.. 2. Disconnect the connector. 3. Remove the hook (1), remove the rod (2) from the air mix actuator link. 4. Remove the screw. 5. Remove the driver-side air mix actuator. 6. Install in the reverse order of removal. Passenger- ...

Engine Tune Up [Mzr 2.0, Mzr 2.5]
NOTE: If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not indicate a malfunction. Engine Tune-up Preparation 1. Verify ...

� 2016-2026 Copyright www.mazda3tech.com