Mazda 3 manuals

Mazda 3 Service Manual: Transaxle Oil Inspection [G66 M R]

Mazda 3 Service Manual / Engine / Lubrication / Transaxle Oil Inspection [G66 M R]

1. Park the vehicle on level ground.

2. Remove the aerodynamic under cover No.2..

3. Remove the oil level plug and washer.

4. Verify that the oil is near the brim of the plug port.


Manual transaxle oil

Item

Specification

Grade

API service GL-4

Viscosity

SAE 75W-80


5. Install a new washer and the oil level plug.

6. Install the aerodynamic under cover No.2..

Transaxle Oil Inspection [G35 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. I ...

Transaxle Oil Replacement [A26 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and gasket. 4. Drain the oil into a suitable container. 5. Install a new gasket a ...

Other materials:

Saving Fuel and Protection of the Environment
How you operate your Mazda determines how far it will travel on a tank of fuel. Use these suggestions to help save fuel and reduce CO2. Avoid long warm-ups. Once the engine runs smoothly, begin driving. Avoid fast starts. Drive at lower speeds. Anticipate when to apply the brakes (a ...

Manual Transaxle Oil Inspection [C66 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and gasket. Tightening torque 39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf} 4. Verify that the manual transaxle oil is near the brim of the plug port. Wh ...

Engine Tune Up [Mzr 2.3 Disi Turbo]
NOTE: If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not indicate a malfunction. Engine Tune-up Preparation 1. Verify ...

� 2016-2026 Copyright www.mazda3tech.com