Mazda 3 manuals

Mazda 3 Service Manual: Variable Tumble Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / General / Variable Tumble Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Airflow Inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the variable tumble solenoid valve..

4. Inspect airflow between the ports under the following conditions.



Variable Tumble Shutter Valve Actuator Inspection [Mzr 2.0, Mzr 2.5]
Operation Inspection 1. Remove the air hose.. 2. Disconnect the vacuum hose from the variable tumble shutter valve actuator. 3. Connect a vacuum pump to the variable tumble shutter valve act ...

Variable Valve Timing Actuator Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Variable valve timing actuator can not be disassembled because it is a precision unit. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove ...

Other materials:

AUX/USB/iPod mode
Audio can be heard from the vehicle's speakers by connecting a commerciallyavailable portable audio unit to the auxiliary jack. A commercially-available, non-impedance (3.5 ) stereo mini plug cable is required. Contact an Authorized Mazda Dealer for details. In addition, audio can be p ...

Trunk Lid Key Cylinder Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Lift the clip in the direction of the arrow (1), and pull out the key rod in the direction of the arrow (2). 4. Remove the nuts. 5. Remove the trunk lid key cylinder. 6. Install in the reverse order of r ...

Knock Sensor (Ks) Inspection [Mzr 2.0, Mzr 2.5]
Resistance Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the KS connector. 4. Measure the resistance between KS terminals A and B. If not as specified, replace the KS.. Specification Approx. 4.87 megohms [normal tem ...

� 2016-2026 Copyright www.mazda3tech.com