Mazda 3 manuals

Mazda 3 Owners Manual: Windshield Washer

Pull the lever toward you and hold it to spray washer fluid.

Mazda 3. Windshield Washer


NOTE With the wiper lever in the or intermittent position/ position, the wipers will operate continuously until the lever is released.

If the washer does not work, inspect the fluid level . If the fluid level is normal, consult an Authorized Mazda Dealer.

Windshield Wipers
Turn the wipers on by pressing the lever up or down. With intermittent wiper Variable-speed intermittent wipers Set the lever to the intermittent position and choose the interval timing b ...

Rear Window Wiper and Washer
The ignition must be switched ON to use the wiper. Rear Window Wiper Turn the wiper on by turning the rear wiper/washer switch Rear Window Washer To spray washer fluid, turn the rear wip ...

Other materials:

Starter Cut Relay Inspection [MTX]
Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable. 2. Remove the following parts: a. Front scuff plate (LH). b. Front side trim (LH). c. Side wall. d. Console. 3. Set the bonnet release lever out of the way.. 4. Remove the lower panel.. ...

Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Install the SSTs to the master cylinder (secondary side) as shown in the figure. NOTE: When installing the SST (49 D043 0A0) to the master cylinder, use a commercially available flare nut wrench (flare nut across flat 12 mm {0.47 in}). ...

Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]
ECT Sensor No.1 Resistance inspection WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Drain the engine coolant.. 4. R ...

� 2016-2026 Copyright www.mazda3tech.com