Mazda 3 manuals

Mazda 3 Service Manual: Body And Accessories

Mazda 3 Service Manual / Vehicle general / Body And Accessories

ABBREVIATIONS


ACC

Accessories

AUX

Auxiliary jack

CAN

Controller Area Network

DLC

Data Link Connector

GND

Ground

LH

Left Hand

RH

Right Hand

USB

Universal Serial Bus


FEATURES

Abbreviations
ABS Antilock Brake System ABDC After Bottom Dead Center ACC Accessories ALC Auto Level Contr ...

Body And Accessories SST
49 L067 001 Reflector 49 L067 002 Tripod 49 L067 003 Plum-bob 49 L067 006 Plum-bob ...

Other materials:

DSC HU/CM Removal/Installation
WARNING: If the DSC HU/CM configuration is not completed, it could result in an unexpected accident due to the DSC being inoperative. If the DSC HU/CM is replaced, always use the automatic configuration function so that the DSC operation conditions are correct. If the DSC se ...

Wheel Unit Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Install the valve core and valve cap, put air into the tire. CAUTION: A TPMS wheel unit has an exclusive valve cap and valve core. If a valve core other than the exclusive one is installed, ...

Rear Shock Absorber Disposal
1. Clamp a rear shock absorber on a flat surface or with the piston pointing downwards. 2. Drill a 2—3 mm {0.08—0.11 in} hole at a point 40—50 mm {1.6—1.9 in} from the bottom of the tube, so that the gas can escape. WARNING: Whenever drilling into a rear shock absorber, w ...

� 2016-2026 Copyright www.mazda3tech.com