Mazda 3 manuals

Mazda 3 Owners Manual: Brake

Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission — which may not be long enough for HomeLink to pick up the signal duri ...

Brake System
...

Other materials:

Antenna Feeder No.2 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. A-pillar trim (RH). b. Rear seat cushion (4SD). c. Rear scuff plate (RH). d. Tire house trim (RH). e. Trunk side upper trim (5HB, RH). f. Trunk side trim (5HB, RH). g. C–pillar trim (RH). 3. Disconnect t ...

Antenna Amplifier Removal/Installation
With Audio Unit (Without Display) 1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the fo ...

Oil Control Valve (OCV) Inspection [Mzr 2.0, Mzr 2.5]
Coil Resistance Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the OCV connector. 5. Measure the resistance between terminals A and B using an ohmmeter. OCV coil resistance 6.9—7.9 ohms [20°C ...

� 2016-2026 Copyright www.mazda3tech.com