Mazda 3 manuals

Mazda 3 Owners Manual: Fuel and Engine Exhaust Precautions

Mazda 3 Owners Manual / Before Driving / Fuel and Emission / Fuel and Engine Exhaust Precautions

Fuel and Emission
...

Fuel Requirements
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED FUEL, which will reduce exhaust emissions and keep spark plug fouling to a minimum. This vehicle will perform best wit ...

Other materials:

Wheel Hub Component Inspection
Wheel Bearing Excessive Play Inspection 1. Remove the brake caliper component and disc plate.. 2. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play. If it exceeds the maximum specification, replace the wheel hub compon ...

Drive Plate Removal/Installation [Fw6 A EL]
1. Remove the transaxle.. 2. Remove in the order indicated in the table. 1 Drive plate installation bolts (See Drive Plate Installation Bolts Removal Note.) (See Drive Plate Installation Bolts Installation Note.) 2 Backing plate ...

Heated Oxygen Sensor (HO2 S) Inspection [Mzr 2.0, Mzr 2.5]
HO2S Inspection 1. Connect the M-MDS to the DLC-2. 2. Switch the ignition to ON. 3. Warm up the engine to normal operating temperature. 4. Access the following PIDs using the M-MDS.. VSS (Vehicle speed) RPM (Engine speed) O2S12 (HO2S output voltage) 5. Drive ...

� 2016-2026 Copyright www.mazda3tech.com