Mazda 3 manuals

Mazda 3 Service Manual: Gps Antenna Feeder Removal/Installation

Mazda 3 Service Manual / Accessories / Electronics / Navigation / Gps Antenna Feeder Removal/Installation

With Audio Unit (Without Display)

NOTE:

1. Refer to MULTI INFORMATION DISPLAY REMOVAL/INSTALLATION.

With Audio Unit (With Display)

NOTE:

1. Refer to ANTENNA FEEDER NO.4 REMOVAL/INSTALLATION.

Gps Antenna Feeder Inspection
With Audio Unit (Without Display) 1. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the GPS antenna feeder. With Audio Unit ( ...

No.1 Car Navigation System Does Not Start Operation [Car Navigation System]
1 Even if the NAVI mode is selected, the car-navigation system screen does not display. Possible DTC — POSSIBLE CAU ...

Other materials:

Power Outer Mirror Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Inner garnish. b. Front door trim. c. Switch panel. 3. Verify that the continuity between the power outer mirror switch terminals is as indicated in the table. If not as indicated in the table, replace t ...

Front Door Hinge Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light. c. Front fender molding. d. Side step molding. e. Front fender panel. f. Front door. 3. Remove in the order indicated in the table. 1 B ...

Rear Package Trim Removal/Installation
1. Remove the following parts: a. Rear seat cushion. b. Rear scuff plate. c. Tire house trim. d. C-pillar trim. 2. Fold the rear seat back. 3. Remove the fasteners. 4. Pull up the rear package trim in the direction of the arrow (1) shown in the figure while remove the clips and p ...

� 2016-2026 Copyright www.mazda3tech.com