Mazda 3 Service Manual: Electronics

Cruise Control Switch Inspection [Mzr 2.3 Disi Turbo]

1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the driver–side air bag module.. 4. Disconnect the clock spring connector (part wir ...

Entertainment

...

Other materials:

Rain Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it. 3. Disconnect the rain sensor connector. 4. Slide rain sensor tab B in the direction of the arrow shown in the figure and detach tab B. ...

Manual Transaxle Oil Inspection [C66 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and gasket. Tightening torque 39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf} 4. Verify that the manual transaxle oil is near the brim of the plug port. When the ma ...

Air Intake Actuator Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. If the operation condition is not normal, replace the air intake actuator. ...