Mazda 3 manuals

Mazda 3 Service Manual: Entertainment

Electronics
...

Antenna Amplifier Inspection
1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system ...

Other materials:

Fuel Requirements
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED FUEL, which will reduce exhaust emissions and keep spark plug fouling to a minimum. This vehicle will perform best with fuel listed in the table. * U.S. federal law requires that octane ratings be posted on gasoli ...

DRL (Daytime Running Light) Bulb Removal/Installation
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo 1. Disconnect the negative battery cable.. 2. Disconnect the connector. 3. Rotate the DRL bulb in the direction of the arrow shown in the figure to remove it. 4. Remove the DRL bulb. 5. Install in the reverse order of removal. SKYACTIV-G 2.0 ...

Drive Shaft Inspection
1. Inspect the connections for any looseness. If there is any malfunction, tighten or replace the applicable part. 2. Inspect the dust boot for damage and cracks. If there is any malfunction, replace the applicable part. 3. Move the spline and joint up and down, left ...

� 2016-2026 Copyright www.mazda3tech.com