Mazda 3 Service Manual: Audio Unit Removal/Installation
Without Display
CAUTION:
-
When installing the audio unit, make sure that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the wiring harness or the antenna feeder is caught between the unit and dashboard, it may cause malfunctions.
-
Pressing the switch area of the audio unit when installing it could result in a malfunction. Therefore only press the hatched area shown in the figure.
1. Disconnect the negative battery cable..
2. Remove the center panel..
3. Remove in the order indicated in the table.
|
1 |
Screw |
|
2 |
Clip |
|
3 |
Connector |
|
4 |
Audio unit |
4. Install in the reverse order of removal.
With Display
CAUTION:
-
When installing the audio unit, make sure that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the wiring harness or the antenna feeder is caught between the unit and dashboard, it may cause malfunctions.
-
Pressing the switch area of the audio unit when installing it could result in a malfunction. Therefore only press the hatched area shown in the figure.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. center panel.
b. Passenger-side front scuff plate.
c. Passenger-side front side trim.
d. Dashboard under cover.
e. Glove compartment.
f. Passenger-side lower panel.
3. Remove the screws.
4. Remove in the order indicated in the table.
|
1 |
Screw |
|
2 |
Clip |
|
3 |
Connector |
|
4 |
Audio unit |
5. Remove the bolt.
6. Remove the bracket.
7. Install in the reverse order of removal.
Audio Unit Disassembly/Assembly
CAUTION:
When disassembling the audio unit, it could get scratched if it is placed
directly on the ground. When disassembling the audio unit, spread a soft cloth
underneath to perform th ...
Auxiliary Jack Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Upper panel.
b. Shift lever knob (MTX).
c. Selector lever knob (ATX).
d. Shift panel.
e. Side wall.
f. Consol ...
Other materials:
Sunroof Motor Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the rain sensor cover. (Vehicles with auto light/wiper system).
3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)
4. Partially peel back the seaming welts.
5. Remove the following parts:
a. Sunroof seaming ...
Rear Beltline Molding Removal/Installation
1. Fully open the rear door glass.
2. Remove the rear door trim..
3. Remove clip A using a fastener remover and pull up the rear beltline molding
in the direction of the arrow (1) shown in the figure.
4. Remove clip B using a fastener remover and pull up the rear beltline molding
in the di ...
Side Wall Removal/Installation
1. Pull out the side wall in the direction shown in the direction of the arrow
shown in the figure, then remove the clips.
2. Remove the side wall in the direction of the arrow shown in the figure.
CAUTION:
When remove the side wall, be careful not to damage the guide.
3 ...
