Mazda 3 manuals

Mazda 3 Service Manual: Antenna Feeder No.6 Removal/Installation

Mazda 3 Service Manual / Accessories / Electronics / Entertainment / Antenna Feeder No.6 Removal/Installation

NOTE:

1. Refer to CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.

Antenna Feeder No.6 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Console. g ...

Antenna Feeder No.7 Inspection
1. Disconnect the negative battery cable.. 2. Remove the liftgate upper trim.. 3. Disconnect the connector A and B.. 4. Verify that the continuity between antenna feeder No.7 terminals is as ind ...

Other materials:

Glove Compartment Removal/Installation
CAUTION: If the glove compartment is closed without being joined to the stay damper, the stay damper may be damaged. Verify that the stay damper is joined to the glove compartment before closing the glove compartment. 1. Pull the stay damper in the direction (1) shown in the figu ...

Fuel Line Pressure Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. To prevent this, complete the following inspection with the engine stopped. Fuel is very flammable liquid. If fuel spills or leaks ...

Blower Motor Removal [Manual Air Conditioner]
NOTE: The blower motor is located on the A/C unit as shown in the figure. Perform the work from the front passenger side in the posture shown in the figure. 1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable. 3. Remove the following ...

� 2016-2026 Copyright www.mazda3tech.com