Mazda 3 manuals

Mazda 3 Service Manual: Controller Area Network (Can) System

Mazda 3 Service Manual / Electrical / Data Network / Controller Area Network (Can) System

Outline

System Wiring Diagram


CAN Signal Table

MS-CAN

OUT: Output (sends signal)IN: Input (receives signal)

Signal

Multiplex module

AUDIO UNIT

MULTI INFORMATION DISPLAY/INFORMATION DISPLAY

USB ADAPTER

Text data

–

IN

OUT

Playback information

IN

–

OUT

OUT

IN

–

Operation signal

OUT

–

IN

USB device state

IN

–

OUT


Body Control Module (Bcm) Removal/Installation
CAUTION: When replacing the BCM, the configuration procedure must be performed before removing the BCM. Replacing the BCM without performing the configuration procedure will result in sy ...

On Board Diagnostic System PID/Data Monitor Inspection [FS5 A EL]
NOTE: The PID data screen function is used for monitoring the calculated value of input/output signals in the module. Therefore, if the monitored value of the output parts is not within ...

Other materials:

Camshaft Position (CMP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
Visual Inspection CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration i ...

Oil Control Valve (OCV) Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the wiring harness. 5. Remove the ignition coils.. 6. Remove the ventilation hose. 7. Remove the oil level gauge. 8. Remove the cylinder head cover.. 9. Remove in th ...

Sae Standards
In accordance with new regulations, SAE (Society of Automotive Engineers) standard names and abbreviations are now used in this manual. The table below lists the names and abbreviations that have been used in Mazda manuals up to now and their SAE equivalents. ...

� 2016-2026 Copyright www.mazda3tech.com