The hazard warning lights will flash once.
The following method will also arm the theft-deterrent system: Press the door-lock switch “ ” while any door is open and then close all of the doors.
(With the advanced keyless function) Press a request switch.
The security indicator light in the instrument panel flashes twice per second for 20 seconds.

NOTE
Refer to Transmitter on .
Operation
To Turn Off an Armed SystemEngine Tune Up [Mzr 2.3 Disi Turbo]
NOTE:
If the accelerator pedal is depressed continuously for a specified time,
the engine speed may decrease to the idle speed. This is due to the fuel cut
control operation, which prevents overheating, and it does not indicate a malfunction.
Engine Tune-up Preparation
1. Verify ...
Front Beltline Molding Removal/Installation
1. Fully open the front door glass.
2. Disconnect the negative battery cable..
3. Remove the inner garnish..
4. Remove the front door trim..
5. Remove the power outer mirror..
6. Remove clip A using a fastener remover and pull the front beltline molding
in the direction of the arrow (1) ...
Blind Spot Monitoring (BSM) Warning Lights/Blind Spot Monitoring (BSM)
Warning Beep
The Blind Spot Monitoring (BSM) or Rear Cross Traffic Alert (RCTA) system
notifies the
driver of the presence of vehicles in adjacent lanes to the rear of your vehicle
using the
Blind Spot Monitoring (BSM) warning lights and the warning beep while the
systems are
operational.
Blind Spot Mo ...