Mazda 3 manuals

Mazda 3 Owners Manual: Theft-Deterrent System

If the theft deterrent system detects an inappropriate entry into the vehicle, which could result in the vehicle or its contents being stolen, the alarm alerts the surrounding area of an abnormality by sounding the horn and flashing the hazard warning lights.

The system will not function unless it's properly armed. So when you leave the vehicle, follow the arming procedure correctly.

Immobilizer System
The immobilizer system allows the engine to start only with a key the system recognizes. If someone attempts to start the engine with an unrecognized key, the engine will not start, thereby hel ...

Operation
System triggering conditions The horn sounds intermittently and the hazard warning lights flash for about 30 seconds when the system is triggered by any one of the following: Unlocking a door ...

Other materials:

Air Fuel Ratio (A/F) Sensor Inspection [Mzr 2.0, Mzr 2.5]
A/F Sensor Inspection 1. Connect the M-MDS to the DLC-2. 2. Switch the ignition to ON. 3. Warm up the engine to normal operating temperature. 4. Access the following PIDs using the M-MDS.. VSS (Vehicle speed) RPM (Engine speed) O2S11 (A/F sensor output current) ...

Joint Shaft Removal/Installation [Mzr 2.0, Mzr 2.3 Disi Turbo, Mzr 2.5]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor connector (axle side) and ...

Oil Pressure Switch Inspection
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before removing the exhaust system. 1. Disconnect the negative battery cable.. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil pressur ...

� 2016-2026 Copyright www.mazda3tech.com