Tweeter Removal/Installation
Car Navigation SystemRear Package Trim Removal/Installation
1. Remove the following parts:
a. Rear seat cushion.
b. Rear scuff plate.
c. Tire house trim.
d. C-pillar trim.
2. Fold the rear seat back.
3. Remove the fasteners.
4. Pull up the rear package trim in the direction of the arrow (1) shown in the
figure while remove the clips and p ...
Schedule 2
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L : Lubricate
C: Clean
T: Tighten
Remarks:
*1 Use of FL-22 is recommended when replacing engine coolant. Using engine
coolant other than FL-22 may
cause serious damage to the en ...
Hazard Warning Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the center panel..
3. Verify that the continuity between the hazard switch terminals is as indicated
in the table.
If not as indicated in the table, replace the hazard warning switch.
4. Apply battery voltage to hazar ...