Mazda 3 manuals

Mazda 3 Owners Manual: Overloading

WARNING Be careful not to overload your vehicle: The gross axle weight rating (GAWR) and the gross vehicle weight rating (GVWR) of the vehicle are on the Motor Vehicle Safety Standard Label on the driver's door frame. Exceeding these ratings can cause an accident or vehicle damage. You can estimate the weight of the load by weighing the items (or people) before putting them in the vehicle.
Driving In Flooded Area
WARNING Dry off brakes that have become wet by driving slowly, releasing the accelerator pedal and lightly applying the brakes several times until the brake performance returns t ...

Driving on Uneven Road
Your vehicle's suspension and underbody can be damaged if driven on rough/uneven roads or over speed bumps at excessive speeds. Use care and reduce speed when traveling on rough/uneven roads or ...

Other materials:

Rear Outer Handle Removal/Installation
1. Fully close the rear door glass. 2. Disconnect the negative battery cable.. 3. Remove the rear door trim.. 4. Remove the service hole cover. 5. Remove the screw from the service hole. NOTE: The screw cannot be removed because of the stopper. 6. Press the tab on the ...

Settings
NOTE Depending on the grade and specification, the screen display may differ. Select the icon on the home screen and display the Settings screen. Switch the tab and select the setting item you want to change. You can customize settings in the setup display as follows: Tab ...

Intermediate Sensor Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the intermediate sensor. a. Set the battery component (ex: battery, battery tray and PCM component) out of the way. b. Disconnect the intermediate sensor connector. c. Switch the ignition to ON (engine off). d. Measure the ...

� 2016-2026 Copyright www.mazda3tech.com