Mazda 3 Service Manual: Trunk Board Removal/Installation
1. Remove the trunk mat in the direction of arrow shown in the figure.
2. Remove the trunk board in the direction of arrow shown in the figure.
3. Install in the reverse order of removal.
Stay Damper Disposal
NOTE:
The stay damper contains colorless, odorless, nontoxic gas.
1. Wear protective eye wear.
2. Position the stay damper horizontally.
3. Drain gas and oil by cutting the posit ...
Trunk Compartment Light Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Disengage the tabs by pressing both ends of the lens in the directions indicated
by the arrows and remove the lens.
3. Remove the trunk compartm ...
Other materials:
Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor
and measure the resistance between passenger compartment temperature sensor terminals
B and D.
If the characteristics of the passenger compartment temperature sensor are
not as shown in the graph, repla ...
Call interrupt
A call can be interrupted to receive an
incoming call from a third party.
Switch to a new incoming call using the
following methods.
Method 1
Press the pick-up button.
Prompt: “Swapping calls.”
Method 2
Press the talk button with a short press.
Say: [Beep] “Swap calls”
...
Drive Plate Removal/Installation [FS5 A EL]
1. Remove the transaxle..
2. Remove in the order indicated in the table.
1
Drive plate installation bolts
(See Drive Plate Installation Bolts Removal Note.)
(See Drive Plate Installation Bolts Installation Note.)
2
Backing plate
...
