Mazda 3 Service Manual: Canister Vent (Cv) Solenoid Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
Except for Mexico
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove in the order indicated in the table.
|
1 |
CV solenoid valve connector |
|
2 |
Evaporative hose No.1 |
|
3 |
Evaporative hose No.2 (See Evaporative hose No.2 removal note.) |
|
4 |
CV solenoid valve |
4. Install in the reverse order of removal.
Evaporative hose No.2 removal note
1. Disconnect the evaporative hose of fuel tank side.
2. Remove the evaporative hose and CV solenoid valve as single unit.
3. Remove the evaporative hose.
Canister Vent (Cv) Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]
Except for Mexico
Airflow inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the CV solenoid valve..
4. Inspect airflow between the ports under the f ...
Catch Tank Inspection [Skyactiv G 2.0]
1. Remove the catch tank..
2. Plug the catch tank of the purge solenoid valve side.
3. Inspect for air leakage when blowing air pressure from charcoal canister side.
If there is air l ...
Other materials:
Rear Window Glass Installation
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
CAUTION:
Proper installation of the glass may be difficult if sealant is cracked or
the glass is pushed out by air pressure when a door is opened/closed with al ...
Rear Center Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear seat cushion.
b. Rear scuff plate.
c. Tire house trim.
d. C-pillar trim.
e. Rear package trim.
f. Rear center speaker.
3. Verify the resistance between the rear center speaker terminals.
If ...
Oil Seal (Differential) Replacement [G35 M R]
1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Remove the aerodynamic under cover No.2..
3. Drain the oil from the transaxle..
4. Remove the front splash shield..
5. Separate the drive shaft and joint shaft from the transaxle..
6. Remove the oil seals u ...
