Mazda 3 manuals

Mazda 3 Owners Manual: Center-Rear Position 2-Point Type Seat Belt*

Mazda 3 Owners Manual / Essential Safety Equipment / Seat Belt Systems / Center-Rear Position 2-Point Type Seat Belt*

Front Seat Belt Pretensioner and Load Limiting Systems
For optimum protection, the driver and front passenger seat belts are equipped with pretensioner and load limiting systems. For both these systems to work properly you must wear the seat belt pro ...

Fastening the Seat Belt
Pull the seat belt tongue to the desired length. Insert it into the seat belt buckle until you hear a click sound. Adjust the belt length. To lengthen the belt, hold the seat belt ...

Other materials:

Clutch Pedal Inspection [C66 M R]
NOTE: For the clutch pedal inspection, note the followings and measure each inspection location. Measure the center of the upper surface of the pedal pad for each inspection. If the distance from the pedal pad to the floor covering is measured, measure the shor ...

Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Install the SSTs to the master cylinder (secondary side) as shown in the figure. NOTE: When installing the SST (49 D043 0A0) to the master cylinder, use a commercially available flare nut wrench (flare nut across flat 12 mm {0.47 in}). ...

Bass Box Inspection
1. Disconnect the negative battery cable.. 2. Disconnect the connector.. 3. Verify the resistance between bass-box terminals. If not within the specification, replace the bass-box. Resistance 0.9—1.1 ohms ...

© 2016-2023 Copyright www.mazda3tech.com