Mazda 3 Owners Manual: Essential Safety Equipment
Important information about safety equipment, including seats, seat belt system, child-restraint systems and SRS air bags.
- Seats
- Seat Belt Systems
- Seat Belt Precautions
- 3-Point Type Seat Belt
- Seat Belt Warning Systems
- Front Seat Belt Pretensioner and Load Limiting Systems
- Center-Rear Position 2-Point Type Seat Belt*
- Seat Belt Extender
- Child-Restraint
- SRS Air Bags
Exterior Overview (5-Door)
Hood
Windshield wiper blades
Moonroof
Doors and keys
Fuel-filler lid
Wheels and Tires
Exterior lights
Rear window wiper blade
Liftgate
Antenna
Child safety locks
Out ...
Seats
...
Other materials:
Heated Oxygen Sensor (HO2 S) Inspection [Mzr 2.0, Mzr 2.5]
HO2S Inspection
1. Connect the M-MDS to the DLC-2.
2. Switch the ignition to ON.
3. Warm up the engine to normal operating temperature.
4. Access the following PIDs using the M-MDS..
VSS (Vehicle speed)
RPM (Engine speed)
O2S12 (HO2S output voltage)
5. Drive ...
Drive Belt Removal/Installation [Mzr 2.0, Mzr 2.5]
MZR 2.0
A/C drive belt removal
1. Remove the aerodynamic under cover No.2 and splash shield as a single unit..
2. Remove the nut shown in the figure and set the power steering pipe component
out of the way.
3. Set the SST as shown in the figure.
NOTE:
Hold the SST by hand unti ...
Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]
CAUTION:
If foreign materials are stuck to the sensor, disturbance by magnetic flux
can cause sensor output to be abnormal and thereby negatively affect control.
Make sure that foreign materials such as iron filings are not stuck to the sensor
during installation.
1. Perform t ...
