Mazda 3 manuals

Mazda 3 Owners Manual: Rear Seat

Seat Warmer
The front seats are electrically heated. The ignition must be switched ON. Press the seat warmer switch to illuminate the indicator light while the ignition is switched ON. The mode changes as ...

Split/One-piece Folding the Seatback
By lowering the rear seatback(s) the luggage compartment space can be expanded. WARNING Do not drive the vehicle with occupants on folded down seatback(s) or in the luggage compartm ...

Other materials:

Transaxle Oil Replacement [A26 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and gasket. 4. Drain the oil into a suitable container. 5. Install a new gasket and the drain plug. Tightening torque 28—51 N·m {2.9—5.2 kgf·m, 21—37 ft·lbf} ...

Intermediate Sensor Removal/Installation [FS5 A EL]
CAUTION: If foreign materials are stuck to the sensor, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect control. Make sure that foreign materials such as iron filings are not stuck to the sensor during installation. 1. Perform t ...

Drive Belt Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the aerodynamic under cover No.2 and splash shield as a single unit.. 2. Rotate the drive belt auto tensioner in the direction shown in the figure and remove the drive belt. 3. Install the drive belt. 4. Verify that the drive belt auto tensioner indicator mark does not exceed ...

� 2016-2026 Copyright www.mazda3tech.com