Mazda 3 Owners Manual: Heating
- Set the mode selector dial to the
position. - Set the air intake selector to the outside air position.
- Set the temperature control dial to the hot position.
- Set the fan control dial to the desired speed.
- If dehumidified heating is desired, turn on the air conditioner.
NOTE
- If the windshield fogs up easily, set the
mode selector dial to the
position. - If cooler air is desired at face level, set
the mode selector dial at the
position and adjust the temperature control dial to maintain maximum comfort. - The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).
Control Switches
Temperature control dial
This dial controls temperature. Turn it
clockwise for hot and counterclockwise
for cold.
NOTE
When the mode is set to or
with the
fan control dial in a position oth ...
Cooling (With air conditioner)
Set the mode selector dial to the
position.
Set the temperature control dial to the
cold position.
Set the fan control dial to the desired
speed.
Turn on the air conditioner by press ...
Other materials:
Electric Vehicle system features
The Subaru Solterra represents a new generation of mobility, where
battery electric vehicle technology significantly differs from traditional gasoline-powered
vehicles in both operation and driving experience.
Instead of relying on internal combustion, the Subaru Solterra uses
energy stored i ...
Air Fuel Ratio (A/F) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING:
A hot engine and exhaust system can cause severe burns. Turn off the engine
and wait until they are cool before removing the exhaust system.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the plug hole plate..
4. Remove the air clea ...
Clutch Pedal Position (CPP) Switch Inspection [Mzr 2.0, Mzr 2.5]
Continuity Inspection
1. Verify that the CPP switch is installed properly..
2. Remove the battery cover..
3. Disconnect the negative battery cable..
4. Disconnect the CPP switch connector..
5. Verify that the continuity between CPP switch terminals A and B when the clutch
pedal is depress ...
