Mazda 3 manuals

Mazda 3 Service Manual: Deflector Removal/Installation

Mazda 3 Service Manual / Body / Roof - Fixed, Leisure / Deflector Removal/Installation

1. Fully open the glass panel.

2. Press the spring in the direction shown by the arrow and remove it from the hook.


3. Remove the deflector.

4. Install in the reverse order of removal.

Roof - Fixed, Leisure
...

Front Drain Hose Installation
CAUTION: If the front drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and ...

Other materials:

Generator Disassembly/Assembly [Mzr 2.0, Mzr 2.5]
CAUTION: Melt the solder quickly, otherwise the diodes (rectifier) and regulator will be damaged by excessive heat. 1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. MZR 2.0 1 Rotor component ...

Liftgate Lower Trim Removal/Installation
1. Remove the liftgate upper trim.. 2. Remove the liftgate side trim.. 3. Remove the screw and fasteners. 4. Pull the liftgate lower trim in the direction of arrow (1), (2), (3), then detach clips A, B, pin C and D from the liftgate. 5. Remove the liftgate lower trim. 6. Install ...

Oil Pressure Switch Removal
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before removing the exhaust system. 1. Disconnect the negative battery cable. 2. Remove the aerodynamic under cover No.2.. 3. Disconnect the connecto ...

� 2016-2026 Copyright www.mazda3tech.com