Mazda 3 manuals

Mazda 3 Owners Manual: Fastening the Seat Belt

Mazda 3. Fastening the Seat Belt


Position the lap belt as low as possible, not on the abdominal area, then adjust the shoulder belt so that it fits snugly against your body.

Mazda 3. Fastening the Seat Belt


3-Point Type Seat Belt
...

Unfastening the Seat Belt
Depress the button on the seat belt buckle. If the belt does not fully retract, pull it out and check for kinks or twists. Then make sure it remains untwisted as it retracts. NOTE If a belt ...

Other materials:

Using the interior lights
Interior lights list Location of the interior lights Outer foot lights (if equipped) Inside door handle lights (if equipped) Rear interior light Footwell lights (if equipped) Front interior lights/personal lights Shift lights Auxiliary box lights (if equipped)/Wireless charge ...

Drive Belt Removal/Installation [Mzr 2.0, Mzr 2.5]
MZR 2.0 A/C drive belt removal 1. Remove the aerodynamic under cover No.2 and splash shield as a single unit.. 2. Remove the nut shown in the figure and set the power steering pipe component out of the way. 3. Set the SST as shown in the figure. NOTE: Hold the SST by hand unti ...

Front Lower Arm Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connec ...

� 2016-2026 Copyright www.mazda3tech.com