Mazda 3 manuals

Mazda 3 Service Manual: Fuel Gauge Sender Unit Removal/Installation

Mazda 3 Service Manual / Body / Driver Info & Control / Fuel Gauge Sender Unit Removal/Installation

MZR 2.0, MZR 2.5

NOTE:

1. Remove the fuel gauge sender unit..

MZR 2.3 DISI Turbo

NOTE:

1. Remove the fuel gauge sender unit..

SKYACTIV-G 2.0

NOTE:

1. Remove the fuel gauge sender unit..

Fuel Gauge Sender Unit Inspection
MZR 2.3 DISI Turbo, SKYACTIV-G 2.0 NOTE: The fuel gauge sender unit is integrated with the fuel pump unit. 1. Disconnect the negative battery cable.. 2. Remove the rear seat cushion.. ...

Body Interior
...

Other materials:

Joint Shaft Removal/Installation [Mzr 2.0, Mzr 2.3 Disi Turbo, Mzr 2.5]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor connector (axle side) and ...

Checking Tire Pressure
When you check the air pressure, make sure the tires are cold —meaning they are not hot from driving even a mile. Remove the cap from the valve on one tire. Firmly press a tire gauge onto the valve. Add air to achieve recommended air pressure. If you overfill the tire, release air ...

Air Filter Removal/Installation [Skyactiv G 2.0]
1. Remove the fuel-filler pipe protector.. 2. Remove in the order indicated in the table. 1 Evaporative hose 2 Air filter 3. Install in the reverse order of removal. ...

� 2016-2026 Copyright www.mazda3tech.com