Mazda 3 Service Manual: Driver Info & Control

Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the connector. 4. Remove the bolt. 5. Remove the horn. 6. Install in the reverse order of removal. ...

Active Command Modes Inspection [Instrument Cluster]

1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “ ...

Other materials:

Steering Gear And Linkage Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
WARNING: Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings before handling the air bag module.. 1. Remove the driver-side front scuff plate.. 2. Remove the driver-side front sid ...

Drive Shaft (Tripod Joint) Disassembly/Assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. 1 Boot band (transaxle side) (See Boot Band (Transaxle Side) Disassembly Note.) (See Boot Band (Transaxle Side) Assembly Note.) 2 Cli ...