Mazda 3 manuals

Mazda 3 Service Manual: No.2 Car Navigation System Does Not Operation [Car Navigation System]

Mazda 3 Service Manual / Accessories / Electronics / Navigation / No.2 Car Navigation System Does Not Operation [Car Navigation System]


2

Even if the map screen is touched, the car-navigation system cannot be operated

Possible DTC

POSSIBLE CAUSE

  • Audio unit malfunction (bad LCD panel)

  • Car-navigation unit malfunction


Diagnostic Procedure


Step

Inspection

Action

1

    DETERMINE IF MALFUNCTION CAUSE IS AUDIO UNIT LCD PANEL

  • Turn the ignition switch to the ON position and launch the audio unit diagnostic assist function.

    (See DIAGNOSTIC ASSIST FUNCTION [AUDIO].)

  • Select diagnostic assist code 01 display inspection.

  • Is the display normal?

Yes

Go to the next step.

No

Replace the audio unit.

(See AUDIO UNIT REMOVAL/INSTALLATION.)

2

    DETERMINE IF MALFUNCTION CAUSE IS CAR-NAVIGATION UNIT

  • Select diagnostic assist code 16 external device connection information clearing.

  • Turn the ignition switch to the OFF position.

  • Turn the ignition switch to the ON position.

  • Launch the audio unit diagnostic assist function.

    (See DIAGNOSTIC ASSIST FUNCTION [AUDIO].)

  • Select diagnostic assist code 15 vehicle NAVI signal verification.

  • Is NAVI (USB) NG displayed?

Yes

Replace the car-navigation unit.

(See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)

No

Replace the audio unit.

(See AUDIO UNIT REMOVAL/INSTALLATION.)


No.1 Car Navigation System Does Not Start Operation [Car Navigation System]
1 Even if the NAVI mode is selected, the car-navigation system screen does not display. Possible DTC — POSSIBLE CAUSE ...

Power Sockets
...

Other materials:

Steering Shaft Inspection
1. Inspect the column bearing for excessive play and damage. 2. Verify that the measurement of the steering shaft indicated in the figure is as specified. If not within the specification replace the steering shaft component. Steering shaft length 315—320 mm {12.41—12.59 ...

Engine Coolant Level Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Blind Spot Monitoring (Bsm) Off Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the BSM OFF switch.. 3. Verify that the continuity between the BSM OFF switch terminals is as indicated in the table. If the continuity is not as indicated in the table, replace the BSM OFF switch. 4. Apply battery po ...

© 2016-2025 Copyright www.mazda3tech.com