Mazda 3 Owners Manual: Picture Quality Adjustment
| WARNING
Always adjust the picture quality of the rear view monitor while the
vehicle is stopped:
Do not adjust the picture quality of the rear view monitor while driving
the vehicle. Adjusting the picture quality of the rear view monitor such as brightness, contrast, color, and tint while driving the vehicle is dangerous as it could distract your attention from the vehicle operation which could lead to an accident. |
Picture quality adjustment can be done while the shift lever is in reverse (R).
There are four settings which can be adjusted including, brightness, contrast, tint, and color.
When adjusting, pay sufficient attention to the vehicle surroundings.
- Select the
icon on the
screen to display the tabs. - Select the desired tab item.
- Adjust the brightness, contrast, tint, and color using the slider.
If you need to reset, press the reset button.
- Select the
icon on
the screen to close the tab.
Variance Between Actual Road Conditions and Displayed Image
Some variance occurs between the actual road and the displayed road. Such
variance in
distance perspective could lead to an accident. Note the following conditions
that may cause
a variance in d ...
Interior Features
Use of various features for ride comfort, including air-conditioning and
audio system. ...
Other materials:
Gps Antenna Feeder Removal/Installation
With Audio Unit (Without Display)
NOTE:
GPS antenna feeder is removed with the multi information display.
1. Refer to MULTI INFORMATION DISPLAY REMOVAL/INSTALLATION.
With Audio Unit (With Display)
NOTE:
GPS antenna feeder is removed with the antenna feeder No.4.
1. Re ...
Maintenance requirements
For the Subaru Solterra, consistent daily care and properly scheduled
maintenance are ключовими факторами для забезпечення
безпечної, ефективної та економічної експлуатації.
Власник автомобіля нес ...
Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection
1. Inspect the power supply circuit for the VSS.
a. Remove the insulator from the transaxle.
b. Disconnect the VSS connector.
c. Switch the ignition to ON (engine off).
d. Measure the voltage at VSS connector terminal A (harness-side).
If there is a ...
