Mazda 3 Service Manual: Restraints SST [Standard Deployment Control System]

Pressure Sensor Removal/Installation [Two Step Deployment Control System]

1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Remove the bolts. 6 ...

Restraints SST [Two Step Deployment Control System]

49 H066 002 Deployment tool 49 D066 002 Adapter harness 49 L066 002 Adapter harness 49 G066 ...

Other materials:

Vanity Mirror Illumination Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover into the service hole, and pry it in the direction indicated by the arrow to remove the lens. 3. Remove the vanity mirror illumination bulb. 4. Install in the reverse order of removal. ...

Front Side Marker/Front Turn Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Slightly bend back the front mudguard.. 3. Rotate the front side marker/front turn light socket in the direction of the arrow shown in the figure. 4. Remove the front side marker/front turn light bulb. 5. Install in the reverse order of ...

Ignition Switch Inspection [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the ignition switch.. 4. Verify that the continuity between the ignition switch terminals is as indicated in the table. If not as indicated in the table, replace the ignition switch. ...