Mazda 3 manuals

Mazda 3 Service Manual: Restraints SST [Two Step Deployment Control System]

Mazda 3 Service Manual / Engine / Control / Information / Restraints SST [Two Step Deployment Control System]


49 H066 002

Deployment tool


49 D066 002

Adapter harness


49 L066 002

Adapter harness


49 G066 003

Adapter harness


49 N088 0A0

Fuel and Thermometer checker


49 B066 004

Adapter harness



Restraints SST [Standard Deployment Control System]
49 H066 002 Deployment tool 49 D066 002 Adapter harness 49 L066 002 Adapter harness 49 B066 ...

Seat Track Position Sensor Removal/Installation [Two Step Deployment Control System]
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1min or more.. 3. Remove the front driver’s seat.. 4. Remove the front seat slide adjuster.. 5. Remove t ...

Other materials:

i-ELOOP
On conventional vehicles, the kinetic energy that is generated when the vehicle is decelerated by applying the brakes or during engine braking ends up being discarded as heat. By utilizing this discarded kinetic energy to generate electricity and use it to power the vehicle's electrical dev ...

Hood Release Cable Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the battery tray.. 3. Remove the Front mudguard (LH).. 4. Remove the hood release cable from clips A. 5. Remove the clips B. 6. Disconnect the hood latch from the hood release cable. 7. Remove the hood release cable from outside of ...

Light Switch Inspection
Vehicles Without Auto Light System 1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the light switch.. 4. Verify that the continuity between the light switch terminals is as indicated in the table. If not as indicated in the table, replace the light ...

� 2016-2026 Copyright www.mazda3tech.com