Mazda 3 Service Manual: Seat Warmer Switch Removal/Installation
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the shift panel..
4. Squeeze the tabs of seat warmer switch and pull it outward to remove it.
5. Remove the seat warmer switch.
6. Install in the reverse order of removal.
Seat Warmer Switch Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Inspect for resistance and continuity between the seat warmer switch terminals
using a tester.
If not as s ...
Seat Warmer Unit Inspection
WARNING:
Handling a front seat (with built-in side air bag) improperly can accidentally
operate (deploy) the air bag, which may seriously injure you. Read the service
warnings before han ...
Other materials:
Expansion Valve Removal/Installation
1. Disconnect the negative battery cable..
2. Discharge the refrigerant from the system..
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability
will be lowered and abnormal noise will occur. Always immediately plug all open
fittings after removing ...
EGR Valve Inspection [Mzr 2.0, Mzr 2.5]
Resistance Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Disconnect the EGR valve connector.
4. Measure the resistance between the EGR valve terminals.
EGR valve terminal
Resistance inspection (ohm)
...
No.6 Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing
Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring
(Bsm)]
6
BSM indicator light flashes while not under BSM indicator light-flashing
conditions (no combination switch operation (turn signal switch)
Description
The BSM indicator light flashes despite not satisfying the BSM indicator
l ...
