Mazda 3 manuals

Mazda 3 Service Manual: Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]

Mazda 3 Service Manual / Body / Seats / Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]

CAUTION:

Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION: If any of the following work is performed, perform the seat weight sensor inspection using the M-MDS. Removal of the passenger-side seat Loosening and retig ...

Slide Motor Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the slide motor connector. 4. Apply battery positive voltage to the slide motor term ...

Other materials:

Disc Pad (Front) Replacement [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, pump the brake pedal a few times and verify that the brakes do not drag. 1 Clip 2 Retaining clip (See FRONT BRAKE (DISC ...

Side Air Bag Sensor No. 1 Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the side air bag sensor.. 1. Switch the ignition to off. 2. Disconnec ...

Forced Ignition On [With Advanced Keyless Entry And Push Button Start System]
NOTE: In order to perform a forced ignition ON, the M-MDS (IDS) is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealership for instructions. The forced ignition ON procedure forces a power supply to each part w ...

� 2016-2026 Copyright www.mazda3tech.com