Mazda 3 manuals

Mazda 3 Owners Manual: Start/Stop Engine

Mazda 3 Owners Manual / When Driving / Start/Stop Engine

When Driving
...

Ignition Switch
Push Button Start Positions The system operates only when the key is within operational range. Each time the push button start is pressed, the ignition switches in the order of off, ACC, and ON ...

Other materials:

Back Up Light Switch Removal/Installation [G35 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable. 3. Remove the battery component. (ex: battery, battery tray and PCM component). 4. Remove the aerodynamic under cover No.2.. 5. Drain the oil from the transaxle.. 6. Disconnect the back-up light switch connector and r ...

Rear Oil Seal Replacement [Mzr 2.0, Mzr 2.5]
1. Remove the transaxle.. 2. Remove the flywheel (MTX) or the drive plate (ATX).. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 Bolt 2 Rear oil seal (See Rear Oil Seal Installation Note. ...

Vacuum Pump Inspection [Skyactiv G 2.0]
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump. 2. Install the vacuum gauge as shown in the figure, then check the vacuum. 3. Warn up the engine. If the pressure is less than the specification, inspect for the following. M ...

� 2016-2026 Copyright www.mazda3tech.com