Mazda 3 Owners Manual: Warning Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction.
|
Signal |
Warning Lights |
 |
Master Warning Light *1 |
 |
Brake System Warning Light *1*2 |
 |
ABS Warning Light *1 |
 |
Charging System Warning Light *1 |
 |
Engine Oil Warning Light *1 |
 |
Check Engine Light *1 |
 |
High Engine Coolant Temperature Warning Light *1 |
 |
* Automatic Transaxle Warning Light *1 |
 |
Power Steering Malfunction Indicator Light *1 |
 |
Air Bag/Front Seat Belt Pretensioner System Warning Light *1 |
 |
Low Fuel Warning Light |
 |
Check Fuel Cap Warning Light *1 |
 |
Seat Belt Warning Light |
 |
Door-Ajar Warning Light |
 |
* Low Washer Fluid Level Warning Light |
 |
* Tire Pressure Monitoring System Warning Light *1 |
 |
KEY Warning Light *1 |
 |
* Forward Obstruction Warning/Smart City Brake Support (FOW/SCBS) Warning Light |
 |
* Lane Departure Warning System (LDWS) Warning Light *1*3 |
 |
* Headlight Auto-Leveling Malfunction Indicator Light *1 |
 |
* High Beam Control System (HBC) Warning Light *1 |
 |
* Mazda Radar Cruise Control (MRCC) Warning Light *1 |
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an Authorized Mazda Dealer.
*2 The light turns on continuously when the parking brake is applied.
*3 The light turns on when the system on stand-by. The light flashes when the system has a malfunction.
Warning/Indicator Lights
Instrument Cluster varies depending on model and specifications.
Warning/Indicator lights will appear in any of the highlighted areas ...
Indicator Lights
These lights turn on or flash to notify the user of the system operation
status or a system
malfunction.
Signal
Indicator Lights
* BSM OFF Indicator Light
...
Other materials:
Steering Switch Removal/Installation
WARNING:
Handling the air bag module improperly can accidentally deploy the air bag
module, which may seriously injure you. Read the air bag system service warnings
and cautions before handling the air bag module..
1. Disconnect the negative battery cable and wait for 1 min or mo ...
Windshield Wiper Arm And Blade Adjustment
1. Operate the windshield wipers, and then turn off the windshield wiper motor
to set the wipers in the auto stop position.
2. Slide the serrated connecting part and adjust the windshield wiper arm and
blade so that its end is aligned with the hollowed mark in the ceramic coating.
NOTE: ...
Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the under cover..
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1
Connector
2
Bolt
3
Rear ABS wheel-speed sensor
4
ABS hole cov ...
