Mazda 3 Owners Manual: Indicator Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction.
|
Signal |
Indicator Lights |
 |
* BSM OFF Indicator Light |
 |
* Lane Departure Warning System (LDWS) Indicator Light |
 |
KEY Indicator Light |
 |
* High Beam Control System (HBC) Indicator Light |
 |
Wrench Indicator Light *1 |
 |
TCS/DSC Indicator Light *1 |
 |
DSC OFF Indicator Light *1 |
 |
* AFS OFF Indicator Light *1 |
 |
* Forward Obstruction Warning/Smart City Brake Support (FOW/SCBS) Indicator Light *1 |
 |
* Forward Obstruction Warning/Smart City Brake Support (FOW/SCBS) OFF Indicator Light *1 |
 |
* i-ELOOP Indicator Light |
 |
Low Engine Coolant Temperature Indicator Light |
 |
* Shift Position Indication |
 |
* SPORT Mode Indicator Light |
 |
Headlight High-Beam Indicator Light |
 |
Turn Signal/Hazard Warning Indicator Lights |
 |
Security Indicator Light *1 |
 |
* Mazda Radar Cruise Control (MRCC) Indicator Light |
 |
* Cruise Main Indicator Light |
 |
* Cruise Set Indicator Light |
 |
Lights-On Indicator Light |
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an Authorized Mazda Dealer.
Warning Lights
These lights turn on or flash to notify the user of the system operation
status or a system
malfunction.
Signal
Warning Lights
Master Warning Light *1
B ...
Wrench Indicator Light
When the ignition is switched ON, the
wrench indicator light is illuminated and
then turns off after a few seconds.
The wrench indicator light is illuminated
when the preset maintenance peri ...
Other materials:
Automatic Transaxle Fluid (ATF) Replacement [Fw6 A EL]
WARNING:
Do not perform the servicing while the ATF is hot. Otherwise, it could cause
severe burns or serious injury.
1. Remove aerodynamic undercover No.2..
2. Remove the dipstick securing bolt.
3. Remove the dipstick.
4. Remove the drain plug and washer, and drain the AT ...
Rear Washer Nozzle Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Rear spoiler.
c. High-mount brake light.
3. Disconnect the rear washer hose.
4. Press the tabs and remove the rear washer nozzle.
5. Install in the reverse order of removal.
6. Ad ...
Replacing a Tire
WARNING
Always use tires that are in good condition:
Driving with worn tires is dangerous. Reduced braking, steering, and
traction could result
in an accident.
If a tire wears evenly, a wear indicator will appear as a solid band across
the tread.
Replace the tire when ...
