Mazda 3 manuals

Mazda 3 Service Manual: Inspection After Transaxle Installation [G66 M R]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Information / Inspection After Transaxle Installation [G66 M R]

NOTE:

1. Perform a road test and inspect the following items:

a. No abnormal noise in each shift position.

b. Smooth shift operation when shifting gears.

c. No gear slipout after shifting gears.

d. Back-up light switch operates correctly.

Inspection After Transaxle Installation [G35 M R]
NOTE: Perform the following inspection only when the transaxle has been overhauled. 1. Perform a road test and inspect the following items: a. No abnormal noise in each shift position. ...

Transaxle Fluid Temperature (Tft) Sensor Inspection [FS5 A EL]
CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. ...

Other materials:

Front Shock Absorber And Coil Spring Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connec ...

Engine SST [Mzr 2.3 Disi Turbo]
1: Mazda SST number 2: Global SST number Example 1:49 UN30 3328 2:303–328 Rear oil seal replacer 1:– 2:303–507 Crankshaft TDC timing pin 1:49 UN30 310610 2:303–1061 Camshaft alignment timi ...

Front ABS Wheel Speed Sensor Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, verify that there is no twisting in the front ABS wheel-speed sensor. 1 Connector 2 Front ABS wheel-speed sensor ...

� 2016-2026 Copyright www.mazda3tech.com