Mazda 3 manuals

Mazda 3 Service Manual: Oil Pressure Switch Removal/Installation [FS5 A EL]

Mazda 3 Service Manual / Engine / Lubrication / Oil Pressure Switch Removal/Installation [FS5 A EL]

WARNING:

1. Perform the following procedures.

a. Remove the battery cover..

b. Disconnect the negative battery cable.

c. Remove the aerodynamic under cover NO.2..

2. Remove in the order indicated in the table.



1

Connector

2

Oil pressure switch

3

Washer


3. Install in the reverse order of removal.

Oil Pressure Switch Removal
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before removing the exhaust system. 1. Disconnect the ...

HVAC
...

Other materials:

PID/Data Monitor Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “BSML” or “BSMR”. 3. Select the applicable PID from the PID table. ...

Identification Numbers
Vehicle Identification Number The vehicle identification number legally identifies your vehicle. The number is on a plate attached to the cowl panel located on the left corner of the dashboard. This plate can easily be seen through the windshield Motor Vehicle Safety Standard Label (U.S.A. ...

Clutch Fluid Inspection [C66 M R]
NOTE: A common reserve tank is used for the clutch system and brake system. 1. Verify that the clutch fluid is between the MIN mark and the MAX mark. Verify that there is no clutch fluid leakage then add clutch fluid to the level between the MIN mark and the MAX mark.. ...

� 2016-2026 Copyright www.mazda3tech.com