Mazda 3 manuals

Mazda 3 Service Manual: Sensors, Switches, Relays

Mazda 3 Service Manual / Body / Wipers, Washers / Sensors, Switches, Relays

Windshield Wiper And Washer Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (Driver‘s side). b. Front side trim (Driver‘s side). c. Hood release lever. d. Upper panel. ...

Rain Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it. 3. Disconnect the rain sensor connector. ...

Other materials:

Vanity Mirror Illumination Inspection
1. Disconnect the negative battery cable.. 2. Remove the sunvisor.. 3. Verify that the continuity between the vanity mirror illumination terminals is as indicated in the table. If not as indicated in the table, inspect the bulb. If there is no malfunction, replace the sunvisor. ...

Floor Covering Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front seat. b. Audio amplifier (Vehicles with Bose®). c. Front scuff plate. d. Joint cover. e. Front side trim. f. Fuel-filler lid opener lever bezel. g. Selector lever knob (ATX). h. Shift lever knob (MT ...

Rear Crossmember Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connec ...

� 2016-2026 Copyright www.mazda3tech.com