Mazda 3 Service Manual: Sirius Satellite Radio Antenna Feeder Removal/Installation

Sirius Satellite Radio Antenna Feeder Inspection

SIRIUS Satellite Radio Antenna Feeder No.1 NOTE: SIRIUS satellite radio antenna feeder No.1 is integrated with the dashboard wiring harness. 1. Disconnect the negative battery cable. ...

Sirius Satellite Radio Unit Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Passenger-side front scuff plate. b. Passenger-side front side trim. c. Dashboard under cover. d. Grove compartme ...

Other materials:

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the under cover.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 1 Connector 2 Bolt 3 Rear ABS wheel-speed sensor 4 ABS hole cov ...

Keyless Control Module Removal/Installation
1. If the keyless control module is replaced, always perform the following procedure. Vehicles with immobilizer system Keyless Control Module Configuration. Immobilizer System-related Parts Programming [No.4 Programming Procedure Due to Keyless Control Module Rep ...

Up Switch Inspection [Fw6 A EL]
Continuity Inspection NOTE: The up switch is built into the selector lever component. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the console.. 4. Disconnect the selector lever component connector. 5. Verify that the continuity betwee ...