Mazda 3 manuals

Mazda 3 Owners Manual: Viewing the Display

Guide lines which indicate the width of the vehicle (yellow) are displayed on the screen as a reference to the approximate width of the vehicle in comparison to the width of the parking space you are about to back into.

Use this display view for parking your vehicle in a parking space or garage.

Mazda 3. Viewing the Display


  1. Vehicle width guide lines (yellow) These guide lines serve as a reference to the approximate width of the vehicle.
  2. Distance guide lines.

    These guide lines indicate the approximate distance to a point measured from the vehicle's rear (from the end of the bumper).

    The red and yellow lines indicate the points about 50 cm (19 in) for the red line and 100 cm (39.3 in) for the yellow lines from the rear bumper (at the center point of each of the lines).

CAUTION The guide lines on the screen are fi xed lines. They are not synced to the driver's turning of the steering wheel. Always be careful and check the area to the vehicle's rear and the surrounding area directly with your eyes while backing up.
Displayable Range on the Screen
The images on the screen may be different from the actual conditions. NOTE The displayable range varies depending on the vehicle and road conditions. The displayable range is limited. Ob ...

Rear View Monitor Operation
The operation of the rear view monitor when reversing the vehicle varies depending on the traffic, road, and vehicle conditions. The amount of steering and the timing also varies depending on co ...

Other materials:

To Turn Off an Armed System
An armed system can be turned off using any one of the following methods: Pressing the unlock button on the transmitter. Switching the ignition ON. (With the advanced keyless function) Pressing a request switch on the doors. The hazard warning lights will flash twice. NOTE When th ...

Push-Starting
Do not push-start your Mazda. WARNING Never tow a vehicle to start it: Towing a vehicle to start it is dangerous. The vehicle being towed could surge forward when its engine starts, causing the two vehicles to collide. The occupants could be injured. CAUTION ...

On Board Diagnostic System PID/Data Monitor Inspection [FS5 A EL]
NOTE: The PID data screen function is used for monitoring the calculated value of input/output signals in the module. Therefore, if the monitored value of the output parts is not within the specification, it is necessary to inspect the monitored value of input parts corresponding to ...

� 2016-2026 Copyright www.mazda3tech.com