Mazda 3 manuals

Mazda 3 Service Manual: Car Navigation Unit

Purpose

Function

TomTom Home

LIVE Service

NOTE:

Construction

Terminal layout and signal

Car-navigation unit connector

Terminal

Signal


1A

Ground

1B

Ground

1C

Ground

1D

Ground

1E

—

1F

—

1G

ACC

1H

B+


2A

USB power supply

2B

USB data (+)

2C

USB ground

2D

USB data (+)


GPS/RDS-TMC antenna

Antenna feeder connector

Terminal

Signal


3A

RDS-TMC

3B

GPS


Operation

Fail-safe

Car Navigation System
Outline The car-navigation system displays point-of-origin and road guidance maps via the audio unit display and provides guidance and information to the desired point of destination. ...

Car Navigation Unit Removal/Installation
With Audio Unit (Without Display) NOTE: Car-navigation unit is integrated with the multi information display. 1. Refer to MULTI INFORMATION DISPLAY REMOVAL/INSTALLATION. With Audio U ...

Other materials:

Trunk Lid Opener Lever Removal/Installation
1. Remove the front scuff plate (LH).. 2. Remove the front side trim (LH).. 3. Remove the fuel-filler lid opener bezel.. 4. Partially peel back the floor covering. 5. Remove the bolts. 6. Disconnect the cable and trunk lid opener lever. 7. Install in the reverse order of removal. ...

DSC Sensor Initialization Procedure
WARNING: If the DSC sensor initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the DSC sensor initialization procedure ...

Child Restraint Seat Anchor Removal/Installation
4SD 1. Remove the cover. 2. Remove the bolt and child-restraint seat anchor. 3. Install in the reverse order of removal. 5HB 1. Remove the trunk end trim.. 2. Remove the bolt and child-restraint seat anchor. 3. Install in the reverse order of removal. ...

� 2016-2026 Copyright www.mazda3tech.com