MZR 2.0
1. Remove the generator drive belt with the A/C drive belt still installed and set it out of the way..
2. Verify that the drive belt auto tensioner moves smoothly in the operational direction.

If it does not move smoothly, replace the drive belt auto tensioner..
3. Turn the drive belt auto tensioner pulley by hand and verify that it rotates smoothly.
If it does not move smoothly, replace the drive belt auto tensioner..
4. Install the generator drive belt..
MZR 2.5
1. Remove the drive belt..
2. Verify that the drive belt auto tensioner moves smoothly in the operational direction.

Replace the drive belt auto tensioner if necessary..
3. Rotate the drive belt auto tensioner pulley by hand and verify that it rotates smoothly.
Replace the drive belt auto tensioner if necessary..
4. Install the drive belt..
Drive Belt Auto Tensioner Inspection [Mzr 2.3 Disi Turbo]Liftgate Side Trim Removal/Installation
1. Remove the liftgate upper trim..
2. Pull the point A of the strap hanger as shown in the figure.
3. Remove the strap hanger.
4. Remove the fastener.
5. Pull the liftgate side trim in the direction of arrow then remove clip A.
6. Detach tab B and C while pulling the liftgate sid ...
Reading this manual
Explains symbols used in this manual
Symbols in this manual
WARNING:
In the Subaru Solterra Owner’s Manual, this symbol highlights
critical information that must be followed without exception. Ignoring such instructions
may result in severe injury or even loss of life. Always pay close ...
Winter driving tips
When operating the Subaru Solterra in winter conditions, it is essential
to carry out thorough preparation and regular inspections before driving. Always
adapt your driving style to current weather and road conditions to ensure maximum
safety, efficiency, and vehicle performance.
Pre-winter p ...